3Digi

R2 PROTOTYPING

20 items left



3Digi

    The revolutionary electronic stabilization system for flybarless (FBL) RC helicopters

    3DIGI is ready to use and supports a wide range of interfaces. Connection for setup and tuning can be direct to a computer via a Micro-USB cable (user supplied) or an Android device (using an optional external module) via Bluetooth.

    FEATURES

    •  Advanced 6 Axis MEMS sensor (Gyro and Acceleration)
    • Powerful 32bit ARM Microcontrollers.
    • Integrated R2 micro power bus supplies the internal processor,  sensors and  Spektrum satellites from a minimum input voltage of 1.7 volts. 
    • Optional HC (High Current) version with dedicated power input.
    • Built in vibration analysis (data recording via optional micro SD card).
    • On board Micro USB port for configuration and automatic firmware updates.
    • Simple and friendly Windows based setup Terminal.
    • Android App.
    • Connection for standard Bluetooth modules. 
    • Connector for standard GPS receiver (compatibility list in preparation).RC input supports all popular sum signal inputs (PPM, S-Bus, UDI, Graupner SUMD, Multiplex SRXL, Jeti EX Bus)  or Spectrum satellites.
    • Servo outputs for swash plate (4X), Tail and Throttle.
    • Input for RPM sensor.
    • Status display via 2 LEDs.
    • 3 Parameter Sets (Banks) selectable in flight
    • Live tuning of up to 8 individual parameters in flight allows for fast tuning.
    • Internal event Logging
    • Micro SD slot (Micro SD card is not included) for storage of flight, vibration, and GPS data (with optional external GPS module)
    • Autotrim for precise trimming of the swash plate and tail.

    TECHNICAL SPECIFICATIONS

    • Dimensions approx.: 39.5mm x 32,8mm x 14.6mm
    • Weight approx .: 15g - 0.52 Ounce
    • Operating voltage: 1.7V - 9V (the minimum voltage of the servos used must be observed for trouble-free operation)
    • Sensor: MEMS
    • Processor: ARM 32 bit

    Lukas Dinger having fun with the XNOVA 4530-480KV & 3DIGI

     

    WHAT'S IN THE BOX

    1 x 3Digi (Flybarless System)
    2 x Double-sided adhesive pads

    Instructions Manual (12/19/2015) 

    Set up interface:

    • Input controls for governor
    • Trim of swash and tail now possible with Live Tuning
    • Inverting servo travel in Setup Assistant now also inverts trim function
    • 3Digi firmware higher than V1.2.0 required

     NEW Firmware V1.2.0 (

    • Hint: Before the update save the current Setup as file with old Terminal
    • Governor for electro and nitro, with integration in FlightData and Live Tuning
    • Init sequence changed, solves Kosmik init problem
    • New EventLog entries when reaching the servo limits
    • Swash and tail trim available as Live Tuning
    • Minimum input voltage as Jeti telemetry value
    • Terminal V1.2.X required
    • Updated Jeti Integration files available here

     

    Aditional documentation are downloadable at: www.3digi.de

     

     

    Customer Reviews

    Based on 6 reviews Write a review

    Related Items

    Quick Shop