The revolutionary electronic stabilization system for flybarless (FBL) RC helicopters
3DIGIis ready to use and supports a wide range of interfaces. Connection for setup and tuning can be direct to a computer via a Micro-USB cable (user-supplied) or an Android device (using an optional external module) via Bluetooth.
Advanced 6 Axis MEMS sensor (Gyro and Acceleration)
Powerful 32bit ARM Microcontrollers.
Integrated R2 micropower bus supplies the internal processor, sensors, and Spektrum satellites from a minimum input voltage of 1.7 volts.
Optional HC (High Current) version with dedicated power input.
Built-in vibration analysis (data recording via optional micro SD card).
Onboard Micro USB port for configuration and automatic firmware updates.
Simple and friendly Windows-based setup Terminal.
Connection for standard Bluetooth modules.
Connector for standard GPS receiver (compatibility list in preparation).RC input supports all popular sum signal inputs (PPM, S-Bus, UDI, Graupner SUMD, Multiplex SRXL, Jeti EX Bus) or Spectrum satellites.
Servo outputs for swashplate (4X), Tail, and Throttle.
Input for RPM sensor.
Status display via 2 LEDs.
3 Parameter Sets (Banks) selectable in flight
Live tuning of up to 8 individual parameters in flight allows for fast tuning.
Internal event Logging
Micro SD slot (Micro SD card is not included) for storage of flight, vibration, and GPS data (with optional external GPS module)
Auto trim for precise trimming of the swashplate and tail.
Dimensions approx.: 39.5mm x 32,8mm x 14.6mm
Weight approx .: 15g - 0.52 Ounce
Operating voltage: 1.7V - 9V (the minimum voltage of the servos used must be observed for trouble-free operation)
Processor: ARM 32 bit
Lukas Dinger having fun with the XNOVA 4530-480KV & 3DIGI
WHAT'S IN THE BOX
1 x 3Digi (Flybarless System) 2 x Double-sided adhesive pads